ASTM F436M PDF

pieces, circular washers, hot-dip galvanized, 24 mm, Type 1 ASTM F. M, dated ______. (2) pieces, beveled washers, 22 mm, Type 3,. ASTM, F M. Designation: F M – 93 (Reapproved ) METRIC. Standard Specification for. Hardened Steel Washers [Metric]’ This standard is issued under the fixed. Designation: F M – 93 (Reapproved ) METRIC Standard Specification for ‘This specification is under the jurisdiction of ASTM Committee F on.

Author: Yozshujin Dizragore
Country: Germany
Language: English (Spanish)
Genre: Travel
Published (Last): 2 April 2012
Pages: 371
PDF File Size: 7.67 Mb
ePub File Size: 20.72 Mb
ISBN: 400-1-16657-672-8
Downloads: 52102
Price: Free* [*Free Regsitration Required]
Uploader: Mikaramar

No other units of measurement are included in this standard.

It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

WASHER F436M SILVER ZINC ASTM 10MM

Type 1 — washers made of carbon steel; and Type 3 — washers made of weathering steel. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Steels to be used to adtm the washers shall be produced by the open-hearth, basic-oxygen, or electric-furnace process. Each type and style of washer shall be suitably sampled, and should conform to specified values of chemical composition, Rockwell hardness, inside and outside diameter, thickness, and clipped width.

  ARISTOFANES LAS ASAMBLEISTAS PDF

Link to Active Asym link will always route to the current Active version of the standard.

WASHER FM SILVER ZINC ASTM 10MM ( )

Link to Aetm This link will always route to the current Ashm version of the standard. This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal thread diameters of M12 through M This specification covers the chemical, mechanical, and dimensional requirements for metric hardened steel washers for use with fasteners having nominal thread diameters M12 through M Work Item s – proposed revisions of this standard.

This abstract is a brief summary of the referenced standard.

Historical Xstm s – view previous versions of standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

When properly exposed to the atmosphere, these steels can be used bare asstm for many applications. These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and other internally and f436k threaded fasteners.

  KONVENSI WINA 1969 PDF

Moreover, the styles of washers covered here are: Note 1—This specification is the metric counterpart of Specification F It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

Stay on Page Continue to Compass. The types of washers covered here are: The atmospheric corrosion resistance of these steels is substantially better than that of carbon steel with or without copper addition.

Hardened Washers

Combining values from the two systems may result in non-conformance with the standard. These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and other internally and externally threaded fasteners. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part qstm the standard.